Christie MIRAGE DS+10K-M, Setup Manual

Page: 18 / 72

2-6 Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
Section 2: Installation and Setup
2.1.3 Advanced Optical Alignment
Boresight Alignment Procedure
1. Display the Boresight Test Pattern by pressing the
T
EST
key on the remote keypad or use the built-in
keypad and press the soft key that displays Test on the LCD display, then
U
P
A
RROW
K
EY
to cycle to
Boresight, then Enter, see Figure 2-7 .
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
3. If boresight is required, refer to Figure 2-8 to understand how the adjustment screws on the lens mount
affect the corresponding cross-hairs on the test pattern.
NOTE:
The capscrew, ( Figure 2-9 ) may be under a
plastic cap, remove and retain before adjusting.
4. Use a 5mm Allen™ key to loosen the 3 locking setscrews on the lens mount, see Figure 2-9 , below.
NOTE:
The setscrews must be backed out several turns, so that they do not contact the inner lens mount plate.
F
IGURE
2-7 B
ORESIGHT
P
ATTERN