Installation and Setup
Mirage 4K35 User Manual
35
020-101377-03 Rev. 1 (07-2015)
Set up the lens
1. Remove the projector shroud.
2. Make sure the lens locking lever is in the up position.
3. If attached, remove the rear lens cap from the lens.
4. Slide the lens into the lens mount, aligning all connections.
5. Secure the lens with the lens locking lever (down position).
6. Calibrate the lens motors.
For more details, see
Work with lenses
on page 60,
Remove the projector shroud
on page 34, and
Calibrate the lens motors
on page 79.
Portrait mode
1. Orient the projector in the frame with the lamp door facing downward (as shown).
The maximum tilt angle is ±15 degrees.
2. Set up the customer-supplied mounting frame.
Warning!
Failure to comply with the following could result in death or serious injury.
• Keep fingers and other body parts away from the moving parts in the projector. Motors and fans
may start without warning.
• Tie back long hair, remove jewelry and loose clothing before manually adjusting the projector.
Notice.
Failure to comply with the following may result in property damage.
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Do not operate the projector without a lens installed. Use a lens plug when installing or transporting
the projector.
i
Always install the lens with UP label in the top position to achieve consistent boresight
alignment each time the lens is replaced.
