Connect Devices
Mirage 4K25 Setup Guide
30
020-101362-02 Rev. 1 (01-2015)
Output is available for control of an IR Emitter for active glasses or a polarization device for passive
glasses.
Connect a computer or server
To communicate with a remote computer, server or an existing network, use an RJ-45 cable to
connect the Ethernet hub or switch to the Ethernet port, located on the projector MCPU faceplate.
When using the Christie serial protocol over Ethernet, connect to port 3002.
For applications or equipment using serial communications, use the Christie-proprietary serial
protocol to communicate with the RS422 port or the RS232 ports on the MCPU faceplate.
Set up the ethernet
Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network. To
modify IP settings, or manually enter an address.
1. On the touch panel controller, tap
Menu
>
Configuration
>
Ethernet Settings
>
Modify
IP Settings
.
2. Set the network information for the projector:
• To obtain information automatically from the network, tap
Automatic
.
• To manually enter the network information, tap
Manual
and enter the
IP Address
,
Subnet Mask
and
Gateway
(optional).
3. Click
Ok
.
Notice.
Failure to comply with the following may result in property damage.
The RS232 port located on the MCPU faceplate uses Christie-proprietary protocol and is intended for
Christie accessories or automation controllers only. For more information on the serial commands,
see the
Mirage 4K Serial API Commands Technical Reference (P/N: 020-101449-XX)
.
