3-4
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
Section 3: Operation
3.1.5 Overview of LED and Key States
The LED color of the keys indicates that the key is in one of these states:
•
Amber:
A functionality is available that will affect the displayed image of the projector
•
Blue:
A functionality is available that is relevant to the built-in LCD only and will not affect the displayed
image from the projector
•
Off:
The key is disabled in the current context
•
Power Key:
Used to switch from Standby mode to ON, and from ON to Standby mode; LED always
remains Amber
•
Help Key:
Only available in the On Screen Display (OSD) context; LED is Amber when the menu is being
displayed on the projected image display; when no menu is being displayed, the Help key is still enabled if
the OSD is enabled. It is only disabled when the entire OSD is set to OFF.
•
Auto Key:
Enabled state when the power is ON, and there are no test patterns on the screen. If the power is
OFF or a test pattern displays, the Auto key is disabled.
•
Exit Key:
Is determined in the specific context of the screen being displayed.
•
Input Key:
Enabled when the power is ON. Disabled if the power is OFF.
•
Lens Key:
Enabled when the power is ON. Disabled if the power is OFF.
•
Shutter Key:
Enabled when the power is ON. Disabled if the power is OFF.
•
Menu Key:
Always remains in the enabled state when the power is ON. If the power is off the Menu key is
disabled.
•
Soft Key:
Used to select an action indicated by text above the key on the LCD. If no text is shown, the
associated key is disabled.
•
Convenience Light Key
: toggles the input panel light ON or OFF.
3.1.6 Remote Keypad Commands
Specific keypad commands are explained in
Figure 3-1 Remote Keypad
.
Power ON/OFF
Press and hold
P
OWER
for two seconds or press twice quickly to action the projector ON or OFF. Or press and
release
P
OWER
followed immediately by the
U
P
A
RROW
K
EY
(ON) or
D
OWN
A
RROW
K
EY
(OFF) to
guarantee the correct action (useful if you are unsure of the present state).
NOTES: 1)
After powering down, the lamp cooling fan remains on for approximately five minutes to cool the
lamp.
2)
Avoid turning the projector back on until it has been off for a few minutes. Hot re-strikes of the lamp
will reduce lamp life and may cause the lamp to explode.
Test
Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to
current input.
Press
T
EST
and then cycle by using the
U
P
A
RROW
K
EY
and
D
OWN
A
RROW
K
EY
arrow keys, to cycle in either
direction through the test patterns. Press
E
XIT
to return to the current input.
Summary of Contents for J 2.0 kW
