Christie F100, Installation Manual

Page: 14 / 24

2-6 Pedestal and Frame Installation Manual
020-100734-02 Rev. 1 (11-2011)
Section 2: Installation and Setup
4. Using (4) M8 socket head cap screws and (4) flat washers (
ɸ
8.4), secure the 2 frames to one another using
the 4 mounting points, as shown below. Hand tighten the hardware to allow small adjustments while the
other frames are added to the row.
5. Check the alignment between each frame and make adjustments, as required.
6. Completely tighten the hardware between the frames and pedestals before adding the next row of frames.
Some adjustment of the pedestal feet may be required to achieve a level row.
a. Use a 5mm allen key and two 10mm open ended wrenches to tighten the hardware on the pedestals.
b. Use a 13mm open ended wrench to tighten the hardware securing the frames to the pedestals.
c. Use a 6mm ball driver to tighten the hardware securing the frames together.
7. Snap grommets into the cutouts of the frames on each end of the row. These grommets ensure the cables do
not rub against the metal cutout (see image above).
2.5.3 Adding Additional Rows of F100 Frames
1. Add the second row, beginning with the center and working outward. Complete these steps for each frame
in the next row.
a. Using safe and approved lifting methods, install the next frame over the lower frame, approaching it
from the back.
b. Once the top frame is resting on the lower frame, slide it forward until it is in position.
c. Align the top and bottom frames until all edges are flush and the mounting holes are aligned.
d. Using 6 M8 socket head cap screws and 6 flat washers (
ɸ 8.4) secure the upper frame to the one below.
Hand tighten the hardware at this point to allow for small adjustments as the other frames are added to
the row.
e. Position the next frame in the row. Using 4 M8 socket head cap screws and 4 flat washers ( ɸ 8.4),
secure the frame to the one adjacent to it.
f. Check alignment between each frame and adjust, as required.
g. Tighten all hardware between the top and bottom frames before adding the next row of frames.
h. Snap grommets into the cutouts of the frames on each end of the row. These grommets ensure the
cables do not rub against the metal cutout (see image above).
i. Repeat the above steps to add additional rows of frames until the desired installation is complete.
M8 socket head cap screw
Flat washer
Insert grommet here (1 on each side)
*repeat for every row of frames