Christie F100, Installation Manual

Page: 11 / 24

Section 2: Installation and Setup
Pedestal and Frame Installation Manual 2-3
020-100734-02 Rev. 1 (11-2011)
2.5 Installation
2.5.1 Assemble the Pedestals
Once the pedestal platform is constructed it is essential an external support is
constructed before adding the frames, video wall mounts and LCD Panels to prevent the
display from tipping and causing serious injuries to those at the installation site.
NOTICE!
Depending on the size of the wall, assemble the platform beginning with the center pedestal,
working outwards to the end of each row.
1. Slide 2 pedestals together aligning the front and rear edges.
2. Using a level, adjust the 3 pedestal feet by rotating them until the 2 pedestals are level on all sides and with
each other. Use a 24mm open ended/adjustable wrench to tighten the lock nut on the feet once the required
adjustment is made.
3. Inspect the inside corners of the pedestal to confirm that the pedestal feet remain fully engaged in the
pedestal. If you cannot see any threads at the top of the corner bracket where the foot is installed, then you
have over-extended the pedestal foot and must correct this before moving on.
4. Using a phillips screwdriver, loosen the 8 screws on the rear pedestal skin. Slide the rear skin up and out to
access the mounting points on the pedestal.
Tighten lock nut
once adjustments
are made