Printed circuit boards and sensors
GS Series 630-635 Service Manual
75
020-001224-02 Rev. 1 (08-2018)
4. Remove the harnesses from the clips.
5. To disassemble the connector board, remove the three M3 screws with a Phillips #1
screwdriver.
6. Replace
the connector board.
7. To re-install, follow these steps in reverse order.
R
J8 MB
White connector, and a black wire tube (30 pin)
S
J5 HL
Composed of two white wires, a white connector, and a
black wire tube (two pin)
T
J9 LIGHT SENSOR
Composed of black, yellow, and red wires, a white
connector, and a black wire tube (six pin)
U
J10 FW MOTOR
FPC cable (four pin)
V
J6 VB
Composed of two black wires, a white connector, and a
black wire tube (two pin)
W
J1 V-motor
Composed of yellow, white, red, and blue wires, a white
connector, and a black wire tube (four pin)
X
J2 H-motor
Composed of yellow, white, red, and blue wires, a white
connector, and a black wire tube (four pin)
Item
Male connector on
connector board
Description
Figure
