Service setups
GS Series 630-635 Service Manual
26
020-001224-02 Rev. 1 (08-2018)
Running a remote port performance test
To perform the remote port performance test, complete the following steps.
1. Connect the projector and remote controller using a audio cable.
2. On the IR remote, press Menu.
The image of on-screen display menu is projected.
Completing a picture in picture/picture by picture
function test
Always perform the picture in picture/picture by picture function test after repairing the main board,
or upgrading the scalar firmware. If the performance is not normal,
replace the main board (see
Replacing the main board and I/O board
1. On the IR remote keypad, press Menu > Input Switching > PIP Menu.
2. Set PIP/PBP Enable to On.
3. Ensure each item is functioning normally.
Performing a network function test on the
network port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP address.
a. Plug in the power cord to the projector.
ID
Part name
Description
1
Test equipment
Remote controller
2
Test signal
None
3
Inspection item
Wired remote port performance test
4
Inspection distance
1.8 to 2.2 m
5
Criteria
No abnormal line distortion or noise exist on the screen