Lens sift 2 components
Quantity
Description
1
Ultra short throw lens pogo adapter
3
Boresight extension rods (with red rubber ring)
1
Boresight L-shaped socket key (black)
or
Boresight U-shaped socket key (black)
Required tools
The following tools are required.
•
Long neck #2 Phillips screwdriver
•
L-shaped socket key provided with the lens kit
•
2.5 mm allen key
•
5 mm hex nut driver
•
10 mm hex key wrench
Safety precautions
When installing the ultra short throw lens, observe these important safety rules to avoid personal
injury or damage to the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
•
EXTREME BRIGHTNESS! Make sure no personnel or objects are in the product light path.
Caution! If not avoided, the following could result in minor or moderate injury.
•
All procedures must be performed by Christie qualified technicians.
•
SHOCK HAZARD! Always turn off power when replacing product components.
•
TIP HAZARD! Place the product on a stable surface.
Completing the ultra short throw lens installation
setup
To complete the installation setup, enter UST mode and start a lens calibration.
1. If you have a non-ultra short throw lens, complete the following steps:
a) Install a non-ultra short throw lens in the projector.
b) Power on the projector.
c) Access the Service menu.
Ultra short throw lens installation
Ultra Short Throw Lens Installation Instruction Sheet
3
020-102569-07 Rev. 1 (12-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
