Setting up the projector
Follow these steps to mark the target screen and set up the projector.
1. Make sure the projector is position perpendicular to the projection wall.
2. Mark the size and center of the projection target screen.
Christie recommends the projection image size is at least 25.4 cm (10 inches) larger than the
target screen size.
3. Based on the projection screen size, calculate the setup dimension.
See the Lens specification table (on page 17).
4. Make sure the variation of the B value and the value in the Lens specification table are within
+/-1cm (+/-0.4 inches).
5. Make sure the variation of the M value and the value in the Lens specification are within
+/-1cm (+/-0.4 inches).
Lens specification table
The following table and image provides the lens specifications.
•
P = Projector height
•
A-P = From the top of the projector to the bottom edge of the screen
•
L = From the front of the lens to the rear of the projector
•
B = From the projector back to the projection screen
•
C = From the lens front to the projection screen
•
M = (A-P)+(H/2) = From the top of the projector to the center of the screen
Ultra short throw lens installation
Ultra Short Throw Lens Installation Instruction Sheet
17
020-102569-07 Rev. 1 (12-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
