1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the
projector IMXB faceplate.
2. When using the Christie serial protocol over Ethernet, connect to port 3002.
3. For applications or equipment using serial communications, use the Christie-proprietary serial
protocol to communicate with the RS232 port on the IMXB faceplate.
Configuring the RS232 port
Configure the RS232 port to send Christie serial commands using a standard RS232 serial cable.
1. Select Menu > Communications > Projector Communication.
2. Use the down arrow to select Baud Rate.
3. Select the appropriate baud rate and select Enter.
4. Use the down arrow to select Network Routing.
5. Select the type network routing appropriate for your projector and select Enter.
Setting up the Ethernet
Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network, modify IP
settings, or manually enter an address.
Christie recommends using the Ethernet port on the IMXB as the HDBaseT port is limited to 100 Mb/s.
You cannot change the IP settings using the web interface.
1. From the display panel, use the arrow keys to select IP Settings.
2. To set the type of network, select DHCP or Static.
3. If you selected Static, manually enter the network information for the IP Address, Subnet,
and Gateway.
4. Select Apply and select Enter.
5. Select MENU > Communications > Network Settings.
6. Select Device name.
7. Use the up and down keys to enter the name of the projector.
8. Select Enter.
Connecting devices and establishing communication
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB
45
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
