Projector LED shutter indicators
Identify the shutter LED state colors and meaning.
LED
State
Description
Solid magenta
Shutter closed
The shutter is closed.
In standby, the shutter is always automatically closed and
the magenta light is muted.
Off
Shutter open
The shutter is open.
Turning off the projector
When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the light source off using the projector keypad, press and hold the
button until you
hear a beep.
To turn off the light source using the remote, press and hold the OFF button until you hear a
beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, turn off the projector breaker switch and disconnect from AC
power.
Aligning the image
Only perform image alignment after the projector is fully assembled and powered up in its final
location.
Basic image alignment ensures the image reflected from the DMDs is parallel and well-centered with
the lens and screen. This initial optical alignment is the foundation for optimizing images on the screen
and must be completed before final boresight adjustments. Before beginning, make sure the projector
is properly positioned in relation to the screen.
1. Ensure the projector is positioned in the throw distance range for the particular lens.
2. Display a test pattern.
3. Do a quick preliminary focus and (if available) zoom adjustment with the primary lens.
Do not worry about consistency across the image at this point, just center focus. It is good
practice to have zoom adjustment color and focus adjustment color in the center of its range.
4. Holding a piece of paper at the lens surface, adjust offsets as necessary until the image is
centered within the lens perimeter. A full white field works best for this.
5. If the projector is mounted off center to the screen axis, offset the lens as much as required.
Aim the projector over slightly towards the center of the screen, but use caution when doing
so, as too much tilt will cause excessive keystone distortion.
6. With a framing pattern on screen, double-check projector leveling so the top edge of the image
is parallel to the top edge of the screen.
Installation and setup
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB
28
020-102961-03 Rev. 1 (08-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.