Configuring system settings
HS Series D16-20 User Manual
50
020-001466-01 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
Enabling the 12V Trigger
The 12V trigger is used for electrical projector screens. The projector screen is automatically
lowered or raised when the projector is switched on or off.
1. Select Menu > Configuration > 12V Trigger.
2. To swap, press ENTER.
Enabling high altitude setting
Enable high altitude mode when altitudes >/= 2000 m. The fan operates at high speed to ensure
sufficient air flow for high altitudes; however, the noise level of the projector is increased.
1. Select Menu > Configuration > High Altitude.
2. To swap, press ENTER.
Adjusting the back light settings
Control the back light behavior and timeout setting for the keypad and status LED.
1. Select Menu > Configuration > Backlight Preferences > Keypad Backlight.
2. Select the appropriate setting for keypad backlight.
3. To confirm the selection, press ENTER.
4. Select Menu > Configuration > Backlight Preferences > Status LED.
5. Select the appropriate setting for status LED.
6. To confirm the selection, press ENTER.
Setting the hot key
To directly call out a function without going through the layers of the on-screen display (OSD)
menus, select a specific function for a hot key. User can call this function by pressing the HOT KEY
on remote control.
1. Select Menu > Configuration > Hot-Key Settings.
2. Select the one function for the hot key:
• Size Presets
• Picture Settings
• Default Value
• Detail
• Contrast Enhancement
• Light Source Mode