Adjusting the image settings
HS Series D16-20 User Manual
35
020-001466-01 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
Inverting 3D signal
3D images consist of a series of images (frames) that alternate quickly between two slightly
different view points, corresponding to our left and right eyes. When these frames are displayed
fast enough and viewed with 3D glasses synchronized to the left/right (L/R) changes, the resulting
image appears with the same depth and perspective that is sensed in the real world.
If the projector generates the sync internally and content is displayed without 3D sync in the cable
connected to the projector, there is a 50% chance that the content is displayed with the left/right
eyes swapped. This function is used for swapping the sequence of the image to make the resulting
image appear normally.
1. Select Menu > Image Settings > 3D Display > 3D Invert.
2. To swap, press ENTER.
Setting the 3D sync output signal
This function is used for controlling and processing the 3D sync output signal.
1. Select Menu > Image Settings > 3D Display > 3D Sync Out.
2. Select the appropriate 3D sync out setting.
• To Emitter—If the 3D sync out port is connected to an emitter, select To Emitter to
transmit 3D signal to emitter and give to 3D glasses.
• To Next Projector—Multiple projectors 3D application only. Select To Next Projector
when the 3D sync out port is not connected to an emitter.
3. To confirm the selection, press ENTER.
Setting the frame delay
Adjust the frame delay which eliminates the odd colors and cross talk caused by timing difference.
Frame delay is the time difference between the first 3D signal being given and the result being
executed from current projector.
1. Select Menu > Image Settings > 3D Display > Frame Delay.
2. Adjust the slider by arrow keys or press ENTER to input the value.
3. After inputting the value, press ENTER to apply.
Setting the left/right (L/R) reference
Set the left/right (L/R) reference for the projector.
1. Select Menu > Image Settings > 3D Display > L/R Reference
2. Select the L/R reference:
• 1st Frame—Set the 1st frame from the input source as the left reference.
• Field GPIO—Set the Field GPIO of the input source as the left and right reference.
3. To confirm the selection, press ENTER.
