Section 5: Parts and Module Replacement
CP2230 Service Manual
5-15
020-100562-06 Rev. 1 (05-2016)
5.7.4 Cardcage Exhaust Fans - Bottom (2 fans)
The bottom cardcage fans are located directly under the cardcage assembly. These two fans draw air out of the
light engine/cardcage compartments. The cardcage assembly must be removed to access these fans.
(Estimated Replacement Time: 35 minutes)
1. Remove the front top lid. Refer to
5.5.1 Front Top Lid, on page 5-6.
2. Remove the high security lid. Refer to
5.5.2 High Security Lid, on page 5-6
3. Remove PIB/ICP cover.
Refer to
4. Remove the cardcage
assembly. Refer to
Cardcage Assembly, on
page 5-22
5. Using a 3mm hex key,
remove the two screws
securing the fan
compartment cover plate
to the base. (
Figure 5-19
)
6. Using a 3mm hex key,
remove the four screws
securing the bottom
cover/fan assemblies to
the base. (
Figure 5-19
)
7. Pull the fans off the
bottom cover’s rubber
isolators.
8. Reverse instructions to re-install the bottom cardcage fans. Use needle-nose pliers to pull the rubber
isolators through the fan mounting holes.
5.8
Feet
Use of the projector’s rear safety strap, or
hold-down bracket if using the optional rack stand, is
MANDATORY in any installation. Ensure the strap is in
place during replacement of the projector’s feet to prevent
the projector from tipping. Keep three of the projector’s
feet on the table at all times!
(Estimated Replacement Time: 12 minutes average between
front and rear + 15 minutes for image adjustment)
1. Using a 19mm wrench, loosen the foot lock nut. (
)
2. Loosen the foot until it is no longer engaged in the baseplate.
Remove.
3. Replace feet repeating instructions in reverse. In some cases, the
displayed image will require some tweaking to display correctly.
Figure 5-19 Cardcage Exhaust Fans
19 mm wrench
Figure 5-20 Replace Feet
