Section 5: Parts and Module Replacement
CP2230 Service Manual
5-39
020-100562-06 Rev. 1 (05-2016)
b. Loosen the screw on the cathode nut and anode clamp. (
)
c. Carefully slide the clamp off of the lamp.
d. Handling by the cathode end only, unscrew the lamp from the cathode connector while supporting the
anode end. Carefully guide the lamp through the reflector to remove it from the projector. Immediately
place it inside the protective cover or original packaging.
CAUTION! Handle the lamp by the
cathode/anode end shafts only, never the glass.
e. Place the lamp on the floor where it cannot fall or be bumped.
WARNING! Handle box with
extreme caution - the lamp is hazardous even when packaged. Dispose of lamp box
according to safety regulations for your area.
3. Install new lamp.
a.
Remove the protective cover from the new lamp by removing the tape, knurled nut and locking star
washer securing it to its cover.
Figure 5-56 Remove Lamp