5
sTeP 1: eNviroNmeNT CHeCk
STEP 1: ENVIRONMENT CHECK
Before setting up and installing the projector and Captiva Touch,
ensure that the interactive cable works for the installation location of
the mount in advance.
Note:
Make sure the projector is installed under the following conditions:
- The projected image is a rectangular shape without any distortion.
- The projector is tilted at an angle no more than +/-3 degrees
vertically and horizontally in relation to the screen.
- When using the interactive function, install the projected image
within reach by hand.
- Do not install the projector or screen in a location subject to direct
sunlight. If the projector or the screen is subject to direct sunlight, the
interactive function may not operate correctly.
a. Captiva Touch installation information
Before installing the Captiva Touch module, the projection surface
must meet the following conditions/criteria:
The screen surface is a flat, smooth unwrapped surface with
1.
no unevenness of more than 5 mm. The surface can be a
flat wall or a whiteboard. For details on how to check surface
flatness, see page 8.
The surface must allow for the Captiva Touch to be fixed with
2.
screws.
If the projection surface meets the criteria above, the projector and
Captiva Touch can then be installed in one of the following ways:
Mount the projector to the wall and the Captiva Touch to the
1.
whiteboard.
Mount the projector and Captiva Touch to the wall.
2.
Captiva Touch User Manual
020-000838-01 Rev. 1 (08-2015)
Summary of Contents for Captiva Touch
Page 1: ...USER MANUAL Captiva Touch 020 000838 01...
Page 32: ......