CHOWEL / PATC-150A-EU
- 24 -
Program No.
Inputs
PILOT 1 PILOT 2 PILOT 4 PILOT 8
1
1
0
0
0
2
0
1
0
0
3
1
1
0
0
4
0
0
1
0
5
1
0
1
0
6
0
1
1
0
7
1
1
1
0
8
0
0
0
1
9
1
0
0
1
10
0
1
0
1
11
1
1
0
1
12
0
0
1
1
13
1
0
1
1
14
0
1
1
1
Only when three PILOT INPUT signals are coincided with each other when
checked and confirmed in synchronization with the power supply, the sequence will
start.
-
WELD / NO WELD INPUT
When this input signal is ON, the operation mode is WELD, and when off,
NO WELD.
In the test mode, if the pilot signal is set at ON, the sequence will be in the
self-holding status.
Connect this signal to the weld sequence initiation signal.
When not used, keep this signal short-circuit to ON.
-
COUNT RESET
When this signal is turn ON, only the counter that has completed counting is
reset to 0 and the COUNT UP OUTPUT is turned to OFF.
Note that this signal is neglected while the sequence is active.
Connect this signal to reset the counter.
When not used, keep this signal open.
-
STEPPER RESET
When this signal is turned ON, the step no. and the step counter are reset and
the STEPPER COMPLETE OUTPUT is turned OFF.
Connect this signal to the signal that resets the stepper.
Note that this signal is neglected while the sequence is active.
When not used, keep this signal open.
Summary of Contents for PATC--150A-EU
