24
Figure 2
2.7 QUARTZ SLEEVE INSTALLATION
CAUTION
LAMPS AND QUARTZ SLEEVES ARE MADE OF GLASS AND ARE EXTREMELY
DELICATE. TAKE CARE WHEN HANDLING OR REPLACING THESE
COMPONENTS. WEAR COTTON GLOVES WHEN HANDLING LAMPS. HOLD
LAMPS BY THE ENDS ONLY. NEVER TOUCH THE GLASS WITH BARE HANDS.
WIPE ANY FINGERPRINTS FROM LAMPS WITH ALCOHOL.
QUARTZ SLEEVES ARE SHIPPED WITH SMALL RUBBER STOPS INSIDE THE
BOTTOM OF THE SLEEVE. THIS RUBBER STOP MUST REMAIN IN PLACE TO
PREVENT DAMAGE FROM LAMP INSTALLATION.
Place a gasket on the quartz sleeve quick disconnect flange. Carefully lower the quartz
sleeve assembly into the chamber. On stainless chambers for SAG480 through
SAG1200, the quartz sleeves sit on top of spring assemblies. Quartz sleeves must be
carefully lined up with the spring or damage to the sleeve may occur. When the quartz
sleeve is properly located in the spring assembly the quick disconnect quartz sleeve
assembly will rest about ¼” to ½” above the 2” gasket. Gently press the quick
disconnect quartz sleeve assembly into place and install the quick disconnect clamp to
secure the sleeve in place.
Inlet
Outlet
