Installation Instructions
K4W120-210-310
11
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the K4W Series mount up to (and
including) the display does not exceed 15 lbs (6.8 kg) per
display.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily thread into display
mounting holes.
NOTE:
Supplied screws (M, N and P) may not fit properly for
all displays. See display’s operating instructions for
details.
Flush Mounting Holes
IMPORTANT ! :
For the K4W120, lower display must be
installed before installing upper display!
1.
Using Phillips screwdriver, carefully install two M4 x 12mm
Phillips pan machine screws (P) into the
upper
mounting
holes on the display. Thread screws completely into display,
then back out 3 complete turns. (See Figure 14)
Figure 14
2.
Pick up and align display so that screws (P) (installed on the
back of the display in the previous step) fit into the mounting
holes on the faceplate. Lower the display firmly into place.
(See Figure 14)
3.
Using Phillips screwdriver, install two M4x12 mm
Phillips pan machine screws (P) through the
lower
mounting holes on faceplate into the display.
(See
Figure 15)
Figure 15
4.
Tighten all four screws (P). Do not over-tighten!
NOTE:
If roll adjustment is desired for center faceplate, do not
tighten screws.
5.
Repeat Steps 1-4 for other displays.
6.
Proceed to Wall Cover Installation Section.
Recessed Mounting Holes
IMPORTANT ! :
For the K4W120, lower display must be
installed before installing upper display!
NOTE:
If faceplate does not fit into recessed area of display,
proceed with the steps in this section.
1.
Determine depth of recessed mounting holes relative to
back surface of display (against which faceplate will
contact).
2.
Select proper length spacer and screw from table below:
NOTE:
All spacers used should be the same length. If the
recess depths result in multiple spacer lengths, then
select the longer spacer.
CAUTION:
Using screws of improper size may damage
your display! Proper screws will easily and completely thread
into display mounting holes.
3.
Using Phillips screwdriver, carefully install two selected
screws (N or M) through selected spacers (Q or R) into the
upper
mounting holes on the display. Thread screws
completely into display, then back out 3 complete turns.
(See Figure 16)
faceplate
(array arm not shown for clarity)
(P) x 2
1
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8” or less
Q (3/8” long)
N (M4 x 20mm)
More than 3/8” up to
and including 3/4”
R (3/4” long)
M (M4 x 30mm)
faceplate
(array arm not shown for clarity)
(P) x 2
3
