Installation Instructions
K1W/K1S Series
13
2.
Carefully place display face down on protective surface.
3.
Connect faceplate to display
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x10mm screws (B) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 9)
Figure 9
For recessed mounting hole installation:
•
Place four spacers (D) on top of mounting holes
on back of display. (See Figure 10)
•
Using Phillips screwdriver, carefully install four
M4x20mm screws (C) through corresponding
holes on faceplate, spacers (D) and into the
mounting holes on the display. (See Figure 10)
Figure 10
4.
Position display with faceplate attached above mount. (See
Figure 11)
5.
Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 11)
Figure 11
Handle Installation (K1W22/K1S22 models only)
1.
Loosen four screws securing handle brackets to K1W22/
K1S22 array. (See Figure 12)
2.
Install uprights of handle (J2) into handle brackets located
on the back of array. (See Figure 12)
Figure 12
(for flush mounting holes)
(B) x 4
quick release
faceplate
3
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
5
2
2
(J2)
1
x 4
