K1W/K1S Series
Installation Instructions
14
3.
Position handle (J2) at desired height and secure by
tightening button head cap screws attaching handle
brackets to array. (See Figure 13)
Figure 13
Adjustments
Pitch Adjustment (non-array models)
1.
Adjust pitch to desired tilt position. (See Figure 14)
2.
Adjust pitch tension screw to change the adjustment
tension. (See Figure 14)
Pivot Adjustment (non-array models)
3.
Adjust pivot position as desired. (See Figure 14)
4.
Use 3/16” hex key (K) to adjust pivot point tension screws to
change pivot adjustment tension. (See Figure 14)
Figure 14
Rotational Adjustment
NOTE:
(Optional) Rotational adjustment may be locked by
installing rotational locking screw (K) into back of
faceplate. (See Figure 15)
Figure 15
5.
The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
14)
6.
Use 3/16” hex key (K) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 14)
Lift Arm Tension Adjustment
1.
Tension may also be adjusted with upper tension
adjustment screw inside cable management cover and 1/8”
hex key (N). (See Figure 16)
Figure 16
3
3
3
x 4
pitch
pivot point
tension
tension
5
1
3
Rotational tension
6
(K)
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
