K1W/K1S Series
Installation Instructions
12
Array Installation (K1W22H/K1S22H ONLY)
1.
Slide rotational spacer (J10) into opening on array
attachment bracket. (See Figure 7)
2.
Use 5/16-18 x 3" button head cap screw (J3), two thin steel
washers (J8), plastic spacer (J9), pocket washer (J5), pivot
pin (J4), pivot point spacer (J12) and 5/16-18 lock nut (J6)
to secure array (J1) to K1 arm (A). (See Figure 7)
NOTE:
Cable clip (J11) can be used in place of pivot point
spacer (J12) if additional cable management is desired.
(See Figure 7)
Figure 7
Display Installation
1.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 8)
Figure 8
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the K1W/K1S Series Monitor Arm
up to (and including) the display does not exceed the weight
limits listed below. Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
(J10)
1
(J3)
2
(J9)
(J8) x 2
(J5)
(J1)
(J4)
(J6)
(A)
(J12)
or
(J11)
quick release lever
1
1
MODEL
Max Weight
Allowed for EACH
Display
Max Weight
Capacity of
Mounting System
K1W110
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K1W120
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K1W120XRH
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K1S120
25 lbs
(11.34 kg)
25 lbs
(11.34 kg)
K1W220
25 lbs
(11.34 kg)
50 lbs
(22.68 kg)
K1W220XRH
25 lbs
(11.34 kg)
50 lbs
(22.68 kg)
K1S220
25 lbs
(11.34 kg)
50 lbs
(22.68 kg)
K1W22H
9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
K1S22H
9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
