Installation Instructions
CTV-3036
9
STEP 4
Figure 9. Determine Mounting Area of Monitor
Figure 10. Attach Side Brackets to End Trays
Attaching Side Brackets to End Trays
Attach side brackets to end trays, as follows:
NOTE:
The top mounting area (size) of your monitor is
required to determine which set of end tray
mounting holes to use.
1. Determine the top mounting area of your monitor.
See Figure 9. If necessary, use a tape measure.
2. With the mounting area (size) in mind, position the
assembled side brackets (40) at the mid point of the
monitor top.
3. Mark the location of the set of holes in the end trays
(20 or 30) that are closest to mounting holes in the
side bracket (40). See Figure 10.
4. Align the holes and install two M6 square nuts (GG),
two flat washers (DD), and two M6 X 25mm Phillips
head cap screws (FF) in the mounting holes as shown
in Figure 10. Tighten the cap screws (FF) securely.
5. Repeat procedure to attach the other side bracket to
the other end tray.
(70)
(90)
(GG)
(40)
(10)
(30)
(DD)
(FF)
