Installation Instructions
CTV-3036
10
STEP 5
Figure 11. Measure Width of Display
Figure 12. Place Monitor on Mount
Placing the Monitor on the Center Tray
Place the monitor on the center tray, as follows:
1. Determine the width of your monitor (see Figure 11).
If necessary, use a tape measure.
2. Slide the end plates (20 and 30) to match the width of
your monitor. See Figure 12.
3. Tighten all four cap screws (CC) on bottom of trays
(20 and 30). Refer to Figure 11.
WARNING:
Monitors are usually heavy and difficult to
move. Exercise extreme caution when
moving the monitor to avoid personal
injury and/or equipment damage.
4. With the assistance of another person, carefully place
the monitor on the center plate. Slide the monitor
onto the center tray (10) from the back end to avoid
lifting the monitor over the retaining edge of the
center tray.
5. Firmly push the roll out brackets (70) inward until
they make contact with your monitor. See Figure 12.
6. Firmly press down on the top placement brackets (90)
until they make contact with your monitor.
7. Tighten the flat head screws (EE) on both sides.
8. Check the mount to ensure that the mounting brackets
are adjusted correctly. The brackets should fit tightly
around your monitor. If not, repeat steps 2 through 7
until the monitor is secure.
20 and 30
90
EE
70
