Installation Instructions
CMA395
3
TOOLS / PARTS FOR INSTALLATION
ASSEMBLY AND INSTALLATION
The 100 degree angled ceiling plate is designed for ease of
installation with any height of ceiling. By using any length of
standard NPT 1 1/2" pipe with both ends threaded, the height
capabilities may be extended as needed.
1.
Loosen two angle adjustment screws to angle of pipe
coupler to be adjusted. (See Figure 1)
2.
Adjust pipe coupler to desired angle. (See Figure 1)
3.
Tighten two angle adjustment screws. (See Figure 1)
4.
Install extension pipe in coupler and secure using the set
screw (C). (See Figure 1)
Figure 1
5.
If necessary, remove hex head bolt running through pipe
channel in order to allow cables to be routed through pipe.
(See Figure 2)
NOTE:
If cables are small enough to fit between bolt and pipe,
bolt does not need to be removed.
6.
Route cables through pipe as needed. (See Figure 2)
7.
Reinstall hex head bolt and nut after cables have been
properly routed. (See Figure 2)
Figure 2
5/32"
(Included)
A (1)
B (1)
5/32"
[CMA395 assembly]
3/4"
9/16"
extension pipe
4
(C)
2
1
3
5
(A)
7
6