![background image](http://html.mh-extra.com/html/chief/cel024854/cel024854_manual_2601205033.webp)
33
MI300T 220V
q j
The memory space is sufficient to ensure an autonomy of more than 65,000 points.
The machine can operate without a memory card in «manual» mode only.
If the memory card is not inserted in the card reader, the following message appears. The machine must be
stopped and restarted after inserting the SD card.
Important :
It is necessary to turn off the power to the machine before removing the SD card from its rea
-
der and restart the machine only after inserting the SD card into its reader, otherwise the data saved on the
SD card may be lost.
ASSEMBLY AND REPLACEMENT OF THE ARMS ON THE G CLAMP
The warranty does not cover anomalies and damages due to improper assembly of the G-clamp arms.
IMPORTANT :
- do not use copper grease on the arms.
- keep the arm base and arm support on the clamp clean to ensure a good flow of current between the parts in contact.
- If not used for a long time, always store the machine with an arm mounted on the clamp to avoid dust on the arm support.
Procedure for changing the arms :
During the replacement of the arms on the clamp, the cooling circuit pump must be switched off. To do this, place yourself in the «Clamp Setting»
mode on the machine; the red light on the clamp button (FIG 2 -12) indicates that the pump is off. The electrode retracts into the clamp to allow the
arm to be removed.
1
The latch sticks out on the lock side
2
The lever must be in the rear position stop (~120°)
3
The arrows must be aligned
4
Tilt the arm about 15° and remove it from its housing (the pins must slide into the groove)
1
4
3
2
2
1
3
4
MECHANICAL OVER-OPENING OF THE ARM
To open the arm and gain easier access to the bodywork, activate the over-opening by pressing the clamp button (FIG 2 -10).
1
Press the button (FIG 2 -10)
2
The latch sticks out on the open lock side
3
The lever must be open (~90°) at the stop on the latch.
4
The arrows must not be aligned
Incline the arm.
4
2
3
1
2
4
3
1
EN