Large Flat Panel
Single Arm Wall Mount, Model 25MWR
™
The 25-MWR is wall-mounted,
rugged, versatile, and
installer-friendly. The 25-MWR is compatible with the
midsized (200 x 200mm) and 25-MSB interfaces in which
a display can be mounted in either the landscape or
portrait position.
The single arm on the 25-MWR:
•
Extends from the wall 24-7/8” in length
•
Pivots up to 90º left or right of center
The standard 25-MWR is shipped with the support post
for the single arm centered in the mount. The support
post can be moved laterally right or left of center to
readily accommodate sites with limited wall space.
The tilt range for the display is 5º up and 15º down.
The 25-MWR was designed for fast installation. After
drawing the plumb line and installing the two top lag
bolts into the dual wall studs, the installer hangs the
MWR on its top bracket and installs two lag bolts in the
bottom bracket. Next, the installer mounts the display
and connects the power/audio/video cables, which are
diverted into the built-in path in the flexible single arm.
After making the lateral, rotational, and tilt adjust-
ments, the installation process is complete.
BEFORE YOU BEGIN
•
Caution: To prevent damage to the 25-MWR, which could affect or void the Factory warranty, and to the equip-
ment that will be attached to it, thoroughly study all instructions and illustrations before you begin the
installation. Pay particular attention to the “Important Warnings and Cautions” on Page 2.
• The combined weight of the components installed on the 25-MWR must not exceed 125 lbs. (56.7kg).
•The 25-MWR wall mount must be installed on dual wall studs or supporting framework. The wall to which the 25-MWR is
anchored must be capable of supporting
five times
the total weight of the mount and all attached equipment.
• If you have any questions about this installation, contact us at 1-800-888-6024.
I N S T A L L A T I O N I N S T R U C T I O N S
Summary of Contents for 25MWR
Page 3: ...3 Installation Instructions DIMENSIONAL DRAWING...
Page 12: ......
