Installation Instructions
6
1. Mount the top bracket on the 25 MWR, as follows:
WARNING: Improper installation can result in serious
personal injury!
a.With an assistant, lift and hang the 25 MWR on the
two lag bolts and washers previously installed on
the wall. See Figure 2.
NOTE: Make sure washers are installed in front of the
top bracket, not behind the bracket.
b.Slide the 25 MWR into the desired position on the
wall and tighten the two lag bolts.
2.Mount the bottom bracket on the 25 MWR, as follows:
a.
Mark the two mounting holes in the bottom
mounting bracket (see Figure 3). Make sure to
align the holes parallel to the holes drilled in the
top bracket.
b. Drill two pilot holes in the wall studs, as follows:
• If using 5/16” lag bolts, use a 7/32” drill bit.
• If using 3/8” lag bolts, use a 9/32” drill bit.
c.
Install two lag bolts and two washers into the
pilot holes.
• If you used a 7/32” drill bit, use 5/16” lag bolts
(40) and 5/16” washers (50).
• If you used a 9/32” drill bit, use 3/8” lag bolts
(not supplied) and 3/8” washers (not supplied).
d. Tighten the two lag bolts.
Use Lag Bolts and Washers to
.
Figure 3. Mount Bottom Bracket on Wall
Mount the 25-MWR
Mount (Hang) the 25-MWR on Lag Bolts
Figure 2. Mount 25-MWR on Lag Bolts
Fasten 25-MWR to the Wall
Summary of Contents for 25MWR
Page 3: ...3 Installation Instructions DIMENSIONAL DRAWING...
Page 12: ......
