5
Installation Instructions
MWR INSTALLATION
WARNING: Improper installation can result in serious
personal injury!
WARNING: It is the responsibility of the installer to verify
that the wall to which the 25-MWR is anchored
will safely support
five times
the combined
load of all attached components and equip-
ment. If not, reinforce the structure before
installing the 25-MWR.
Locate Wood Studs 16” Apart on Center
1. Determine the exact mounting location prior to installa-
tion, considering screen size and the unit’s total swing
arm radius. Keep in mind that the 25-MWR must be
mounted to wood studs that are 16” apart on center.
NOTE:Mount the 25-MWR between parallel wall studs
or other supporting framework that is vertical
or horizontal.
2. Using a stud sensor, locate the two wood studs where
you will mount the 25-MWR.
3. Draw a level plumb line to indicate the desired height of
the top mounting bracket.
4.With an assistant, lift and hold the 25-MWR against wall.
Use a pencil, awl, or small nail to mark the mounting
holes where two pilot holes will be drilled into the cen-
ter of the wood studs. Make sure the mounting holes are
level.
5.With an assistant, lay the 25-MWR down on the floor.
6. Drill two pilot holes where the mounting holes were
marked for anchoring the top bracket on the 25-MWR. See
Figure 1.
NOTE: Do not tighten the lag bolts down at this time.
Leave enough space between the wall and lag
bolts to hang the 25-MWR.
NOTE: Lag bolts and flat washers are not supplied.
7. Install two lag bolts and two flat washers in the pilot
holes drilled in step 6.
Figure 1. Two Wood Studs 16” Apart On Center
16”
Wood Studs
Pilot Holes
Wall
Summary of Contents for 25MWR
Page 3: ...3 Installation Instructions DIMENSIONAL DRAWING...
Page 12: ......
