Installation Instructions
11
Reconfiguring the Swing Arm
to the Left or Right of Center
Perform this procedure to change of the single swing arm
mount configuration.
1. Remove the display from the mount.
2. Remove four bolts (two on the top and two on the bottom)
securing the swing arm assembly to the top and bottom
mounting brackets (see Figure 13).
WARNING: The next step will release the arm assembly
from the mount. The arms and plate may fall
if you are not careful.
3. Move the swing arm assembly to desired location.
• For left of center, see Figure 13.
• For right of center, see Figure 14.
4. Install retaining pin assemblies (one top and one bottom)
and secure using two bolts (one top and one bottom).
5. Install four bolts (two on the top and two on the bottom) to
secure the swing arm assembly to the top and bottom
mounting brackets (see Figure 13).
6. Tighten the bolts.
7. Install the display on the mount.
REMOVE THE DISPLAY
Perform this procedure when maintenance is required.
WARNING: Plasma screens are heavy and extremely
fragile. Exercise caution when removing or
installing the plasma screen to avoid serious
injury.
1. Disconnect power/audio/video cables.
2. Release the locking device (see Figure 4).
3.Using two people, lift the display up from the 25-MWR.
Top Bolts
Figure 13. Adjust Swing Arm – Left of Center
Figure 14. Adjust Swing Arm – Right of Center
Top Bolts
Summary of Contents for 25MWR
Page 3: ...3 Installation Instructions DIMENSIONAL DRAWING...
Page 12: ......
