SKU 92386
for technical questions, please call 1-800-444-3353.
Page 5
SerVIce
Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. follow instruc-
tions in the
“Inspection, Maintenance, And Cleaning”
section of this manual.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of electric shock or injury.
grOuNDINg
WArNINg!
Improperly connecting the grounding wire can result in the risk of electric shock.
check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. Do not modify the power cord plug provided with the tool.
Never remove the grounding prong from the plug. Do not use the tool if the
power cord or plug is damaged. If damaged, have it repaired by a service facil-
ity before use. If the plug will not fit the outlet, have a proper outlet installed by
a qualified electrician.
grOuNDeD TOOlS: TOOlS WITH THree prONg plugS
Tools marked with “Grounding Required” have a three wire cord and three prong
grounding plug. The plug must be connected to a properly grounded outlet. If
the tool should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user, reducing the risk of electric
shock.
(See figure A.)
WArNINg: To reduce the risk of electroncution, keep all connections dry and off
the ground. Do not touch plug with wet hands. Ground Fault Circuit Interrupter
(GFCI) protection should be provided on the circuit(s) or outlet)s) to be used for the
tile saw (GFCI is not included in this machinery). Receptacles are available having
built-in GFCI protection and may be used for this measure of safety.
The grounding prong in the plug is connected through the green wire inside the
cord to the grounding system in the tool. The green wire in the cord must be the
only wire connected to the tool’s grounding system and must never be attached to
an electrically “live” terminal.
(See figure A.)
1.
2.
1.
2.
3.
REV 12/06
