Page 12
SKU 02514
1 I Meter:Water Temperature
2 I Light:Power Supply
3 I Digital:V.A.Hz
4 I High Water Temperature Alarm
5 I
Meter:Oil pressure
6 I
Light:Low Oil Pressure Alarm
7
C
Push button:Emergency Stop
8 C
Circuit Breaker
9 I
Meter: Battery Change Current
11 I
Calculagraph
12 C Switch:Voltage Change 230/115V
13 C
Switch:Run,Off,Preheat,Start
14
I Meter:Fuel Level
Startup
1.
Verify all Pre-start Checks have been completed (see page 10 and 11).
2.
Insert the key into the generator keyswitch .Turn key to "Preheat" for 10 seconds
(Do this only under cold weather conditions).
3.
Turn key switch to “Start” to start the engine. If it does not start in 10 seconds repeat,
step 2.Once the engine starts, turn the Key to "Run".
4.
Set the generator circuit breaker (up) to On. The generator is now supplying power to
the load.
5.
View the ampere and voltage meters on the control panel. Adjust voltage regulator to
change voltage, if necessary. Total ampere should not exceed the maximum capacity of the
generator.
6.
Listen for unusual noises, vibration, or other indications of abnormal operation. Check
for oil leaks and evidence of overheating.
* C = Control, I = Indicator
Controls and Indicators
ITEM C / I *
DESCRIPTION
15 C Push Button:Alarm Reset
10 C Voltage Regulator(A.V.R)
