Chevrolet 2006 Avalanche, Owner'S Manual

Page: 411 / 532

To disconnect the jumper cables from both vehicles do
the following:
1. Disconnect the black negative (
−
) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative (
−
) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the other
vehicle.
5. Return the remote positive (+) terminal cover, if
equipped, to its original position.
Rear Axle
When to Check Lubricant
It is not necessary to regularly check rear axle fluid
unless you suspect there is a leak or you hear an
unusual noise. A fluid loss could indicate a problem.
Have it inspected and repaired.
All axle assemblies are filled by volume of fluid during
production. They are not filled to reach a certain
level. When checking the fluid level on any axle,
variations in the readings can be caused by factory fill
differences between the minimum and the maximum
fluid volume. Also, if a vehicle has just been driven
before checking the fluid level, it may appear lower than
normal because fluid has traveled out along the axle
tubes and has not drained back to the sump area.
Therefore, a reading taken five minutes after the vehicle
has been driven will appear to have a lower fluid
level than a vehicle that has been stationary for an
hour or two. Remember that the rear axle assembly
must be supported to get a true reading.
5-51