CHESTER Super Lux Mill, Operation Manual

Page: 3 / 17

3
injuries to the operator or damage to the machine.
17. Make sure the power switch is in the off position before plugging in the power supply.
18. Never stand on the machine, the machine could tip over or injuries can be caused if the
cutting tool is contacted.
19. Check for any damaged parts before using the machine, check the guards and other
parts to see that they are functioning correctly. Check the alignment of moving parts
and any mounted parts and any other condition that may affect the machines operation.
Any damaged components should be removed and either repaired or replaced before
starting the machine.
20. Only feed the workpiece into a blade or cutter against the direction of rotation of the
blade or cutter.
21. Never leave the tool running unattended, make sure that the machine has come to a
complete stop and the power has been turned off before leaving the machine.
22. Do not operate this machine whilst under the influence of alcohol, drug or medication.
23. Make sure that the power supply is disconnected while the motor is being mounted,
connected or reconnected.
Additional Safety Rules for Mills
1. Be sure that the drill bit or cutting tool is securely locked in the chuck.
2. Be sure that the chuck key is removed from the chuck before turning on the power.
3. Adjust the table or depth stop to avoid drilling into the table.
4. Shut off the power, remove the cutting tool and clean the table before leaving the
machine.
5. Use clamps or a vice to secure the workpiece, do not use your hands as the workpiece
can rotate with the drill bit or cutting tool.
6. Do not use gloves when operating a mill to prevent being caught in the rotating parts.