54
Replacing the Glass Seal
The glass seal is a perishable item and at some point may need changing.
If the glass seal is frayed and starting to leak emissions then it must be replaced.
The seal is
available from most Chesney’s suppliers.
Observe the old seal placement before removing, taking note of the top edge.
Remove the old seal and clean off any dirt and old adhesive. Start from the bottom centre of
the appliance (fig. 127) carefully adhere the seal around the edges then stick part of the seal on
the lip across the top edge then press the seal into the fold (shown in fig. 128 below right) to
ensure a good seal.
Fig. 127
Fig. 128
Replacing the RF receiver control box
Carefully remove the burner and burner base to access the RF receiver control box remove the
remaining wiring, undo the securing clip (fig. 129) lift the lever out of the reset button hole then
remove the box out of the tabs on the bracket (fig. 130-132)
Fig. 129
Fig. 130
Fig. 131 Fig. 132
Refit a genuine replacement RF controls box
IMPORTANT - When refitting ensure the controls box is fitted in the tabs, secured down and
the lever tip located in the reset button hole.
