38
ENG
GIGIO - SILVESTRO - SERBIS
(Rev. 01/07/2012)
35. HOW TO USE THE REAR CONTROL PANEL (in emergency only)
Warning: for SERBIS model, the panel must be positioned so that it is visible and
accessible.
The rear control panel is designed to be used in emergency cases only, (remote control failure or remote loose). The
heart of the system is the remote control. For this reason, only 2 functions can be operated from the real panel: on/off
and power output setting on steps 2 or 5. It is not possible to set the room temperature.
›
Button 3
- On / Off
To switch the stove on: press button for some 3 seconds till the relevant led lights green
To switch the stove off: press button for some 3 seconds till the relevant green led starts
flashing . When the self clearing procedure will be finished it goes out.
›
Covering led
This led confirms the remote control transmission has been correctly covered.
›
Alarm Led
This led lights on when a failure has been detected. The remote control is necessary to
display the failure that did occur. If the stove goes out of pellet, press and keep button
3 to reset the alarm till red led goes off and green led starts flashing. In all other cases,
do not start the stove but call for service.
›
Button 2
- Power output 5
Allows setting the power output on level 5.
Press and keep button 2 for 3 seconds till the relevant led light yellow .
›
Button 1
- Power output 2
Allows setting the power output on level 2.
Press and keep button 1 for 3 seconds till the relevant led light yellow .
