Chauvet MotionOrb, User Manual

Page: 11 / 96

3. Setup
MotionOrb™ User Manual Rev. 1 Page 11 of 96
3. S
ETUP
AC Power
The MotionOrb™ has an internal auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product’s power requirements see the product label, or refer to
Technical Specifications in this manual. The listed current rating indicates the product’s average
current draw under normal conditions.
For more information, download Sizing Circuit Breakers from the CHAUVET® website:
www.chauvetlighting.com/download/ .
Always connect the product to a protected circuit.
Never connect the product to a rheostat or dimmer.
Fuse
Replacement
To replace the fuse, do the following:
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Insert a fuse of the exact same type and rating.
6. Replace the fuse holder back into the slot.
7. Reconnect the product to power.
Fuse
Replacement
Diagram
•
Disconnect the product from power before replacing the fuse.
•
Always replace a blown fuse with another of the same type and rating.
•
A spare fuse is not included; however, the safety cap has room for one.
Installed Fuse
(held by plastic clip)
Spare Fuse Holder
(inside safety cap)
Safety Cap
Spare Fuse
(not included)