2
Ergostyle ™ FX Tables
1 SAFETY PRECAUTIONS
The precautionary instructions found in this
section and throughout this manual are indicated
by specific symbols. Understand these symbols
and their definitions before operating this
equipment. The definition of these symbols are as
follows:
Text with a “CAUTION” indicator will explain
possible safety infractions that could have the
potential to cause minor to moderate injury or
damage to equipment.
Text with a “WARNING” indicator will explain
possible safety infractions that will potentially
cause serious injury and equipment damage.
Text with a “DANGER” indicator will explain
possible safety infractions that are imminently
hazardous situations that would result in death
or serious injury.
Text with a “DANGEROUS VOLTAGE” indicator
serves to inform the technician of possible
hazards resulting in the electrical charge
disbursement from certain components if
handled or serviced improperly.
Throughout this manual, “NOTE” may be found.
These Notes are helpful information to aid in
the particular area or function being described.
1.1 PRECAUTIONARY DEFINITIONS
A. Caution
B. Warning
C. Danger
D. Dangerous Voltage
E. NOTE
1.2 PRECAUTIONARY INSTRUCTIONS
A. Cautions
Read, understand, and practice all precautionary
instructions found in this manual. Know the
limitations and hazards associated with use of
these tables. Observe the precautionary and
operational decals placed on the unit.
Do not use accessories other than those supplied
with the unit or recommended by Chattanooga
Group. The safety of other products has not been
established, and their use could result in injury to
the patient.
This unit should be transported and stored in
temperatures between 0°F and 140°F (-18°C
and 60°C) to prevent damage to the unit or its
components.
DO NOT operate this unit in an environment
where other devices are being used that
intentionally radiate electromagnetic energy in
an unshielded manner. Portable and mobile RF
communications equipment can affect Medical
Electrical Equipment.
This unit generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to other devices
in the vicinity. However, there is no guarantee
that interference will not occur in a particular
installation. Harmful interference to other
devices can be determined by turning this (table,
unit, device, etc.) on and off. Try to correct the
interference using one or more of the following:
reorient or relocate the receiving device, increase
the separation between the equipment, connect
the equipment to an outlet on a different
circuit from that which the other device(s) are
connected and consult the Chattanooga Group
Service Department for help.
The unit should be routinely checked before each
use to determine all controls function normally.
Handle the unit with care. Inappropriate handling
of the unit may adversely affect its characteristics.
Before each use, inspect the table cables and
hoses for wear. Prolonged wear on these
components may cause them to break, which
may cause sudden release of pneumatic pressure.
Test the Patient Switch before each use for power
operation.
•
•
•
•
•
•
•
•
•
Summary of Contents for ERGOSTYLE FX 5820
