13
Baying cabinets together
GF-‐Series GlobalFrame Gen 2 Cabinets can be bayed (fastened) together with solid side panels in place,
with a shared solid or brush side panel between cabinets, or with no side panels, depending on
installation requirements. Cabinets must be the same height and depth.
1.
Remove the hole plugs on top of cabinet frame.
2.
Use the supplied hardware and a 13mm Socket wrench to attach the baying bracket (included in
the hardware kit) to the first cabinet. Make sure to use the correct set of holes for the desired
cabinet spacing (24” or 600 mm). The 24” spacing will center two 600 mm wide cabinets over a 24”
access floor tile – spaces cabinets approximately 0.4” (10 mm) apart. The 600 mm spacing will bay
any two cabinets side-‐by-‐side.
3.
Move the second cabinet so that the cabinets are aligned. This may also require adjusting the
leveling feet if the second cabinet was not set at the same level as the first cabinet.
4.
Use the supplied hardware to attach the baying bracket to the second cabinet.
5.
Repeat steps 1-‐4 for the other end of the cabinet.
24”
600mm
