Chassisworks 5806-U10, Installation Manual

Page: 11 / 16

11
Clevis Tabs Installation
(Weld-In)
Images were shot using a folded
clevis with bolt spacers. Individual
tabs will seat directly against rod
end.
Install rearend housing in the car
at ride height before proceeding.
20. Find a suitable location along
the frame rail or crossmember to
install the clevis tabs.
21. Temporarily install the endlink
using the 3/8” bolts and locknuts.
22. Position the clevis tabs against
the mounting surface and tack
weld the tabs in place.
23. Repeat procedure for opposite
side of vehicle.
24. Check for any clearance issue
with the anti-roll bar throughout
the suspension’s range of travel.
This must be done without springs
installed on the shocks or without
air pressure if using air-spring
shocks.
25. Unbolt the endlink assembly from
the clevis and weld completely
around the tabs.
26. Spray paint bracket and weld area
to protect against rust.