Chassis Plans ATXP-875P, Technical Reference

Page: 41 / 87

ATXP-875P Technical Reference Chapter 2:BIOS Configuration
Chassis Plans 31
Wait for ‘F1’ If Error
Set this value to allow the Wait for ‘F1’ Error setting to be modified. The Optimal and Fail-Safe default setting is
Enabled .
Disabled This prevents the ezPORT to wait on an error for user intervention. This setting should be used if
there is a known reason for a BIOS error to appear. An example would be a system administrator
must remote boot the system. The computer system does not have a keyboard currently attached. If
this setting is set, the system will continue to boot up in to the operating system. If ‘F1’ is enabled,
the system will wait until the BIOS setup is entered.
Enabled Set this value to allow the system BIOS to wait for any error. If an error is detected, pressing <F1>
will enter Setup and the BIOS setting can be adjusted to fix the problem. This normally happens
when upgrading the hardware and not setting the BIOS to recognize it. This is the default setting.
Hit ‘DEL’ Message Display
Set this value to allow the Hit “DEL” to enter Setup Message Display to be modified. The Optimal and Fail-Safe
default setting is Enabled .
Disabled This prevents the ezPORT to display
Hit Del to enter Setup
during memory initialization. If Quiet Boot is enabled, the Hit ‘DEL’ message will not display.
Enabled This allows the ezPORT to display
Hit Del to enter Setup
during memory initialization. This is the default setting.
Interrupt 19 Capture
Set this value to allow option ROMs such as network controllers to trap BIOS interrupt 19.
Disabled The BIOS prevents option ROMs from trapping interrupt 19.
Enabled The BIOS allows option ROMs to trap interrupt 19.
BOOT DEVICE PRIORITY
Boot Device Priority
Use this screen to specify the order in which the system checks for the device to boot from. To access this screen,
select Boot Device Priority on the Boot Setup screen and press <Enter>.
1
st
Boot Device
2
nd
Boot Device
3
rd
Boot Device
Set the boot device options to determine the sequence in which the computer checks which device to boot from. The
settings are
Removable Dev., Hard Drive, or ATAPI CDROM. The Optimal and Fail-Safe settings are:
•
1
st
boot device – Removable Device
•
2
nd
boot device – Hard Drive
•
3
rd
boot device – ATAPI CDROM
To change the boot order, select a boot category type such as Hard disk drives, Removable media, or ATAPI CD
ROM devices from the boot menu. For example, if the 1
st
boot device is set to Hard disk drives, then BIOS will try
to boot to hard disk drives first.
Note:
When you select a boot category from the boot menu, a list of devices in that category appears. For example,
if the system has three hard disk drives connected, then the list will show all three hard disk drives attached.