C-3
** BEFORE USE CHECK FOR LEAKS **
Never check for leaks with a naked eye. Always use a soapy water solution.
NOTE:
Before starting the grill, check for leaks. Make sure the regulator valve is securely fastened to
the burner and the cylinder to prevent fire or explosion hazard when testing for a leak.
Always perform the “Leak Test” as described below before lighting the grill or each time the cylinder is
connected for use.
•
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
•
Conduct leak test outdoors in a well-ventilated area.
•
Do not use matches, lighters or a flame to check for leaks.
•
Do not use grill until any and all leaks are corrected. If you are unable to stop a leak, disconnect the
propane supply. Call a gas appliance serviceman or your local propane gas supplier.
Leak Test
1. In a spray bottle mix 6-9ml. solution, 1 part dish washing soap, 3 parts water.
2. Ensure control valves/burner knobs are in the off position and that regulator is securely connected.
3. Open LP cylinder valve completely by turning wheel counterclockwise.
4. Apply the solution to the hose, gas valve, and regulator, and cylinder.
5. If bubbles form and grow on any of the tested components, there is a leak in the component. No
bubbles means no leak.
6. If a leak has been identified please retest starting with steps 2-5. If leak persists, call customer
service, 912-638-4724 or consult your owner’s manual for how to replace or repair grill components.
Lighting Instructions
Your Char-Griller Griddle is equipped with four individual heat zones all controlled by their own gas
burner. This gives you optimal flexibility to cook multiple types of food on a single surface.
When lighting, keep your face and body as far away from burners as possible and never lean over grill
surface. If grill does not light in 3-5 seconds, turn off the grill and wait 5 minutes for gas to clear before
attempting to relight. Failure to do so may result in an explosive flare-up, which can cause serious bodily
injury or death. Once lit, but before cooking on grill for first time, let grill sit for 15 minutes. This heat
cleans grill’s internal parts from anything they may have come into contact with during manufacturing
and shipping.
NOTE:
Before first use, it is important to properly season your grill to ensure the optimal performance
and long life of your Char-Griller Griddle (see the seasoning/care instruction provided in this manual).
Summary of Contents for Flat Iron 8036
