Wired
In the Wired Tab of the Network settings, you can set the console’s IP information for the
Ethernet port.
First, the console IP Address must be set. From the Home menu on the console, go to Settings,
Network, Wired.
Double-tap to set the IP address to the required IP schemes - see the previous section.
Double-tap to set the subnet mask.
Match your Art-Net devices' IP to be in the same range as the console.
(for example Console IP is 10.0.0.101 and Art-Net device IP is 10.0.0.102, both using a 255.0.0.0
subnet)
Next, Set or check the DMX output on the console. From the Settings menu, go to DMX
settings.
Set Send Over Network to Yes
Set Art-Net Universe, Art-Net universes start at Universe 0. If your node has been set to
receive Art-Net Universe 0,
You would then have console universe 1 being sent out on Art-Net Universe 0.
Wireless
The WiFi connection on the console is used to connect phones and tablets to the console. The
console’s WiFi connection cannot be used to output DMX. Scan the displayed QR code using
the QuickQ remote app on your device.
By default, WiFi is disabled on QuickQ products. On consoles, to enable WiFi, press the WiFi
Icon at the top of the QuickQ Display and toggle on WiFi.
On QuickQ Rack systems, WiFi can be enabled once the unit is on by pressing and holding the
WiFi button on the rack’s rear for two seconds. (On early QuickQ Racks, this button is labeled
recovery
but can still be used to toggle WiFi on/off). The front panel LEDs will flash blue to
indicate the WiFi has been turned on and red to indicate the WiFi has been turned off.
If you need, you can change the console’s IP information for the built-in WiFi. A new QR
image will generate to connect the WiFi with the QuickQ Remote App.
Save to USB Stick button. This will save the QR code and 2 PDF files in A4 and US Letter sizes.
Print out and use to connect.
User Interface Options
48
QuickQ v6
2021-03-12
