5
Installation
Replacing the tracks:
Remove the existing front track, save
mounting hardware.
Install Item 1, from kit using existing
mounting hardware. Seal bolts with putty
supplied in kit.
Install items 2-6 from kit.
5
6
7
8
Install the front door, Item 9 from the kit.
Install item 7 from the kit as shown in
Fig. 3 to reconnect the left and front door
Remove the hardware that connects the
door handle to the right side of the door.
Reinstall the bolts to plug holes.
Carefully remove the wood blocks sup-
porting the right side door & close the
door.
Adjust the spring tension by tightening
the nuts on the spring bolts (see bracket B).
so the doors move freely.
Open the front & side door
and make sure that the door opening
measures 17" in height. Return the doors
to a closed position, if the doors do not
stay completely closed, spring has too
much tension, readjust the nuts on the
spring bolts until the doors remain
closed.
Conversion is complete
9
10
14
15
16
Refer to Fig. 2
Figure 2- Change the Tracks
FRONT
Existing track
(Remove and discard)
Existing
hardware
1
3
4
2
6
5
Adding Door and Door Lift Bracket
Refer to Fig. 3
Remove and discard the front door and
the door catch assembly. The door catch
assembly is mounted to right front inside
of the hood (A).
Figure 3
7
Existing
door linkage
(Remove
and discard)
10
(Viewed from
inside of the
dishwasher)
A
B
Summary of Contents for D-H1M5
