![background image](http://html1.mh-extra.com/html/champion/76526/76526_owners-manual-and-operating-instructions_2588934017.webp)
REV 76526-20140807
14
76526
ENGLISH
OPERATION
Distance from Cleaning Surface
The distance between the spray nozzle and the cleaning
surface affects the impact force of the water. The
impact force of the water increases as the
nozzle is moved closer to the surface. You can vary the
impact force by controlling
• The nozzle’s fan pattern.
• The nozzle’s angle to the cleaning surface.
• The nozzle’s distance from the cleaning surface.
Turbo Nozzle
1. Before triggering the gun, select a nozzle with a wide
fan pattern.
2. Place the nozzle approximately 4-5 ft. (1.2 - 1.5 m)
away from the cleaning surface. Then hold the nozzle
at a 45º degree angle to the cleaning surface. Trigger
the gun.
3. Vary the fan pattern spray angle and the distance
to the cleaning surface until optimum cleaning
efficiency is achieved without damaging the surface.
The turbo nozzle attachment is very powerful and is
not safe for use on all surfaces. Some surfaces may
be more delicate than others and caution should
be exercised when using this attachment. DO NOT
point the turbo nozzle in the direction of any human
being or animal, as this may cause severe injury or
harm.
WARNING
Never use a narrow high impact stream on a
surface that is susceptible to damage. Avoid
spraying windows with a narrow high impact stream
or turbo nozzle. Doing so may break the glass.
WARNING
Your unit is equipped with a quick connect nozzle port.
Choose the appropriate nozzle tip for the job you are
performing.
A wide fan pattern distributes the impact of the water
over a larger area resulting in excellent cleaning action
with reduced risk of surface damage. Clean large surface
areas quickly using a wide fan pattern.
High Pressure Wash
The narrow high impact spray can damage some
surfaces.
CAUTION
Always engage the trigger safety latch when the unit
is not in use.
CAUTION
The trigger safety latch prevents the gun from being
triggered accidentally. Push the latch fully down to
engage it.
Before attaching the turbo nozzle, make sure the
unit is off and has been depressurized.
NOTE
Cold water pressure washer applications only.
NOTE
A standard Zero degree nozzle (not included) delivers
maximum cleaning force to a surface but in the smallest
area. It can cut wood and chip concrete if left on one
spot.
The Turbo Nozzle (included) is a Zero degree nozzle that
rotates rapidly so the cleaning force never dwells on
one spot. The rotating action causes the nozzle to cover
much more area than a standard Zero degree nozzle.
This results in up to twice the cleaning speed of typical
15-40 degree fan nozzles.
To operate the nozzle, simply use the quick connect
feature and attach it to the end of the wand/lance.
When the trigger is pulled and water starts to flow, the
nozzle will spray a rapidly rotating Zero degree stream of
water. Begin spraying about 24 in. (61 cm) away from
the surface being cleaned. Gradually move the nozzle
closer to increase the cleaning/impact force.