If you require parts or service assistance, please call the
CHAMPION TRAPS AND TARGETS Customer Service Dept.
at (800) 379-1732
©
2015 CHAMPION TRAPS AND TARGETS, Anoka, Minnesota 55303
7
3. Attaching Oscillating Base (If purchased with 6-Packer Trap)
1.
The EasyBird Oscillating Base has (4) pre-drilled holes that align with the four mounting
holes on the frame of the 6-Packer trailer. Use (4) of the 10mm x 50mm hex head bolts and
(4) of the 10mm lock nuts supplied with the trailer to securely fasten the oscillating base to
the trailer frame as shown.
The gear motor on the top of the oscillating base is to the
front, the lock down nut and bolt is to the rear.
4. Mounting the Trap
CAUTION! The EASYBIRD 6-PACKER Trap must be bolted down to the trailer or to a flat,
solid surface to eliminate any movement of the trap while operating ! Do not install in an
area that does not allow safe access to the trap during loading and use. Provide ample
clearance around trap. The ON/OFF/SAFE RELEASE switch for the EASYBIRD 6-
PACKER Trap is located on the rear of the trap to allow the trap to be uncocked before
approaching it. Provide for safe access to the switch that will not require anyone to walk
in front of the trap to load targets or perform work on it.
Front of Trailer
Mounting Bolts
If mounting the 6-Packer to the oscillating base
,
Use the 10mm x 20mm hex head bolts (4), 10mm
washers (4) and 10mm lock nuts (4) provided with
the oscillating base to securely fasten the 6-Packer
trap to the oscillating base. Bolts should be inserted
from underneath with the washers and nuts on top
as shown. The mounting bolt that is directly over the
shock absorber can be installed after the oscillating
base is connected and the oscillating base can be
moved slightly using the jog switch.
Mounting Bolts
Mounting Bolts
If mounting the 6-Packer to the trailer
,
Use the 10mm x 20mm hex head bolts
(2) washers (2) and 10mm lock nuts (2)
provided with the trailer to securely
fasten the 6-Packer trap to the trailer as
shown. The curved slot and square hole
in the 6-Packer mounting bracket line up
with the 2 holes in the trailer cross bar.