Champion Power Equipment 75520, Owner'S Manual & Operating Instructions

Page: 12 / 29

9
REV 75520-20121219
ENGLISH 75520
ASSEMbly
Attach the Pressure Gun Assembly
Connect the High Pressure Hose
Take the end of the High Pressure hose that isn’t
connected to the gun inlet and insert it into the
connection on the pump . Rotate hose end (clock wise)
until secure . Tighten connection .
DO NOT OVER TIGHTEN .
Connect the Garden Hose
Take the end of the garden hose that isn’t connected
to the main water supply and connect it to the pump .
Rotate the base of the hose connection until secure .
Tighten connection . DO NOT OVER TIGHTEN .
1 . Attach the wand (A) to the gun (B) .
2 . Rotate the 22 mm nut (clock wise) until the wand is
secure . Tighten connection . DO NOT OVER TIGHTEN .
3 . Connect the end of the high pressure hose (C) to the
gun inlet . Tighten connection clock wise . DO NOT
OVER TIGHTEN .
4 . Slide the Quick Connect sleeve towards the gun .
Insert quick connect nozzle . Be sure the quick
connect sleeve is moved forward to secure the nozzle
in place .
Add fuel Cont’d.
Use regular unleaded gasoline with a minimum
octane rating of 85 .
Do not mix oil and gasoline .
Fill tank to approximately ¼ in . (0 .64 cm) below
the top of the tank to allow for fuel expansion .
DO NOT pump gas directly into the pressure washer
at the gas station . Use an approved container to
transfer the fuel to the pressure washer .
DO NOT fill fuel tank indoors .
DO NOT fill fuel tank when the engine is running
or hot .
DO NOT overfill the fuel tank .
DO NOT light cigarettes or smoke when filling the
fuel tank .
CAUTION
Our engines work well with 10% or less ethanol
blend fuels . When using blended fuels there are
some issues worth noting:
– Ethanol-gasoline blends can absorb more water
than gasoline alone .
– These blends can eventually separate, leaving
water or a watery goo in the tank, fuel valve and
carburetor .
– With gravity-fed fuel supplies, this compromised
fuel can be drawn into the carburetor and cause
damage to the engine and/or potential hazards .
– There are only a few suppliers of fuel stabilizer
that are formulated to work with ethanol blend
fuels .
– Any damages or hazards caused by using
improper fuel, improperly stored fuel, and/
or improperly formulated stabilizers, are not
covered by manufacture’s warranty .
It is advisable to always shut off the fuel supply,
run the engine to fuel starvation and drain the tank
when the equipment is not in use for more than 30
days .
NOTE