REV 75520-20121219
8
75520
ENGLISH
ASSEMbly
1 . Place the pressure washer on a flat, level surface .
2 . Remove oil fill cap/dipstick to add oil .
3 . Add up to 0 .63 qt . (0 .6 L) of oil and replace oil fill
cap/dipstick .
4 . Check engine oil level daily and add as needed .
The engine is equipped with a low oil shut-off and
will stop when the oil level in the crankcase falls
below the threshold level .
CAUTION
Add Engine Oil
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the pressure
washer as a result of failure to follow these
instructions will void your warranty .
CAUTION
Check oil often during the break-in period . Refer to
the Maintenance section for recommended service
intervals .
NOTE
The engine rotor has a sealed, pre-lubricated ball
bearing that requires no additional lubrication for
the life of the bearing .
NOTE
The recommended oil type is 10W-30 automotive oil .
NOTE
Add Engine Oil Cont’d.
Add fuel
1 . Use clean, fresh, regular unleaded fuel with a
minimum octane rating of 85 and an ethanol content
of less than 10% by volume .
2 . DO NOT mix oil with fuel .
3 . Clean the area around the fuel cap .
4 . Remove the fuel cap .
5 . Slowly add fuel to the tank . DO NOT OVERFILL . Fuel
can expand after filling . A minimum of ¼ in .
(0 .64 cm) of space left in the tank is required
for fuel expansion, more than ¼ in . (0 .64 cm) is
recommended . Fuel can be forced out of the tank as
a result of expansion if it is overfilled, and can affect
the stable running condition of the product .
When filling the tank, it is recommended to leave
enough space for the fuel to expand .
Pouring fuel too fast through the fuel screen may
result in blow back of fuel at the operator while
filling .
WARNING
6 . Screw on the fuel cap and wipe away any spilled fuel .
