100536 - 30 iN. 2-STAgE SNOwbLOwER
LONg-TERM STORAgE
22
Lubrication
No parts inside the gearbox are to be lubricated. All bearings and
bushings are permanently lubricated and require no maintenance.
Lubricating these parts will only result in the grease getting on to
the friction wheel and disc drive plate, which could damage the
rubber clad friction wheel.
LONg-TERM STORAgE
Never store the machine with gasoline in the fuel tank in a
confined area with poor ventilation. Gasoline fumes could reach
open flames, sparks, cigarettes, etc.
To avoid the engine freezing and problems starting the engine,
leave the engine running for 5-10 minutes after your work has
been completed. This will ensure all moisture will disappear that
would otherwise cause starting problems.
If the machine is to be stored for a longer period than 30 days, the
following procedures are recommended.
1. Mix fuel stabilizer with gasoline according to fuel stabilizer
manufacturer’s directions.
2. Start the engine and let it run until it stops due to lack of fuel.
3. Change the engine oil if it has not been done for 3 months.
4. Remove the spark plug and empty a little engine oil (about 1
oz {30 mL}) in the hole. Crank the engine a couple of times.
Replace the spark plug.
5. Clean the whole machine thoroughly.
6. Inspect the machine for damage, and repair if necessary.
7. Apply rust protection to the metal surfaces.
8. Store the machine indoors if possible.
Transporting
If the engine has been running, allow it to cool for at least 15
minutes before loading the machine on the transport vehicle. A
hot engine and exhaust system can burn you and can ignite some
materials.
Keep the engine level when transporting to reduce the possibility
of fuel leakage. Move the fuel valve lever to the OFF position.
